Unattended setup
You can install ISA Server 2004 by using the unattended server setup command. For instructions, see Run ISA Server unattended setup.
Note
- To perform this procedure, you must be a member of the Administrators group.
Msisaund.ini contains the configuration information that is used by server setup in unattended mode. It has no effect on the standard ISA Server setup. If a value is not specified in this file, a default value is used. The following table describes the entries and values in the Msisaund.ini file of the server.
| Entry | Description |
|---|---|
| PIDKEY | Specifies the product ID. This is the 10-digit number located on the back of the ISA Server CD-ROM case. |
| INTERNALNETRANGES | Specifies the range of addresses in the Internal network. Msisaund.ini must specify at least one Internet Protocol (IP) address. Otherwise, Setup fails.The syntax is: N From1-To1,From2-To2, … FromN-ToN, where N is the number of ranges, and FromI to ToI are the starting and ending addresses in each range. |
| InstallDir={install_directory} | Specifies the installation directory for ISA Server. If not specified, it defaults to the first disk drive with enough space. The syntax is: Drive:Folder The default folder is: %Program Files%Microsoft ISA Server |
| COMPANYNAME=Company_Name | Specifies the name of the company installing the product. |
| DONOTDELLOGS = {0|1} | If set to 1, log files on the computer are not deleted. The default is 0. |
| DONOTDELCACHE = {0|1} | If set to 1, cache files on the computer are not deleted. The default is 0. |
| ADDLOCAL= {MSFirewall_Management}, {MSFirewall_Services}, {Message_Screener}, {Publish_Share_Directory}, {MSDE} | Specifies a list of components (delimited by commas) that should be installed on the computer. To install all the components, set ADDLOCAL=ALL. |
| REMOVE={MSFirewall_Management}, {MSFirewall_Services}, {Message_Screener}, {Publish_Share_Directory}, {MSDE} | Specifies a list of components (delimited by commas) that should be removed from the computer. To remove all the components, set REMOVE=ALL. Note |
| IMPORT_CONFIG_FILE =Importfile.xml | Specifies a configuration file to import. For more information about importing a configuration file, see Export and import. |
